Users Guide For Atv Ramps
By Gavin Sanderson -
Some people seem to find ramping procedures a piece of cake. But others don’t have such an easy time. For them, ramping is as difficult as filling out their tax returns. It’s true that some people are just naturally better at this sort of thing, but it’s really not that hard to do in the first place. ramping is so easy, in fact, that you don’t even need to practice the procedure before doing it the first time.


Here is some info about the ramping process and how to prepare for it. Follow these simple instructions and you’ll have a trouble-free time. You don’t need to be a rocket scientist to figure out ramping—you just need to adhere to a few basic guidelines.

Choosing an Ramp

If you’ve got a wide runner ramp, your ATV’s wheelbase width should be used as a reference for the width of the ramp. In the same sense, if your preference is for single runner ramps, the width should measure at least as wide as your tire.

Regular-sized ramps are meant to be used with small pickups. The longer variety of ramp is designed for larger trucks. Make sure to check the ramp’s capacity and your ATV’s load. If you believe that your might weigh more than your ramp’s load capacity, then you might be able to take advantage of a feature on some ramps that lets you pair two ramps, increasing load capacity.

Beginning the ramp procedure

Ensure



that your pickup truck is always parked on a firm, flat surface. Also, ensure that everything is turned off and secured on your vehicle before you begin with the ramping. Securing everything means setting the brake and that your trailer (if applicable) is secured as well.

You must then put the ramp on firm ground and at the lowest angle possible on the trailer bed. Attach the ramp to your truck. If you happen to be using runners, ensure that the ramps have the right spacing; they should be matched with your ATV’s wheelbase. The ramp will fit securely and snugly if you’ve done this properly.

Now, put on the safety cables in such a way that they support the ramps tightly with the trailer bed.

Double-check your ramp’s load capacity and what your weighs. Make sure you don’t put all sorts of heavy equipment on your during this process—this might cause overload.

If possible, use a winch when you draw the onto the trailer bed via the ramp. If you can’t, you can drive the up, but make sure to do it very carefully. Take your time. You should accelerate smoothly and slowly. This is where many accidents happen because people accelerate too fast or fall on the side of the ramp. If you’re an novice, you should use the winch.

As a general guideline, it’s always a good idea to have other people around when you’re operating heavy equipment.
Gavin Sanderson provides articles on sports and recreation. Visit online-atv.com and sparringguide.com to find more of his work.

Here are some more atv articles...